ReadSetting with the default is a convenience function reading
settings, not for use in an internal environment. It tries to manage
the default value of a setting.
LoadString: Sanitize input
settings: Handle empty string, remove redundant category
settings: Rename Input to Controls, FS to DataStorage
settings: Fix Controls groups information
settings: Move use_docked_mode to System (again)
settings: Document
settings: Add type identification function
settings: Move registry into values
settings: Move global_reset_registry into values
settings: Separate AdvGraphics from Renderer
settings: More document
squash
settings: Use linkage object
uisettings: Move registry into settings
Probably wont build without
uisettings: Use settings linkage object
config: Load settings with a map
Uses the new all_settings vector to load settings.
qt-config: Rename settings category
qt config: Rename to read category
config: Read/write contols category with for_each
This is extremely limited due to the complexity of the Controls group,
but this handles the the settings that use the interface.
qt-config: Use new settings registry
qt-config: Read/write advgrphics
qt-config: Use settings linkage object
yuzu_cmd: Load setting off of vector
cmd-config: Finish settings rename
config: Read controls settings group with for_each
cmd/config: Move registry into values
cmd: Read adv graphics
cmd-config: Use settings linkage object
This option is only visible if an Intel GPU using the proprietary
driver is found during Vulkan device enumeration.
configure_graphics: More directly get driver id
Vulkan::Device does quite a bit more than we need just to see the
driver ID here.
Previously, yuzu would try and guess which vsync mode to use given
different scenarios, but apparently we didn't always get it right. This
exposes the separate modes in a drop-down the user can select.
If a mode isn't available in Vulkan, it defaults to FIFO.
- add checkbox to disable the controller applet UI
- when controller applet is disabled, use the yuzu-cmd fallback
controller applet that applies controller config based on rules
- See https://github.com/yuzu-emu/yuzu/issues/8552 for some discussion
